ldap_read
(PHP 4, PHP 5, PHP 7, PHP 8)
ldap_read — Read an entry
Опис
Також можливо шукати паралельно.
Тоді перший параметр має бути масивом примірників
LDAP\Connection. Якщо пошуковики мають використовувати
різні базові DN і фільтр, то небхідно передати масив базових DN і/або
масив фільтрів, як параметри. Ці масиви мають бути однакових розмірів з масивом
примірників LDAP\Connection, оскільки перші елементи
масивів використовуються для одного пошуку, другі використовуються для іншого і
так далі. Виконавши паралельний пошук, повернеться масив примірників
LDAP\Result, окрім випадків помилок, коли значення, що
повернеться, буде false
.
Параметри
ldap
-
Примірник LDAP\Connection, якого
повертає ldap_connect().
base
-
The base DN for the directory.
filter
-
An empty filter is not allowed. If you want to retrieve absolutely all
information for this entry, use a filter of
objectClass=*
. If you know which entry types are
used on the directory server, you might use an appropriate filter such
as objectClass=inetOrgPerson
.
attributes
-
An array of the required attributes, e.g. array("mail", "sn", "cn").
Note that the "dn" is always returned irrespective of which attributes
types are requested.
Using this parameter is much more efficient than the default action
(which is to return all attributes and their associated values).
The use of this parameter should therefore be considered good
practice.
attributes_only
-
Should be set to 1 if only attribute types are wanted. If set to 0
both attributes types and attribute values are fetched which is the
default behaviour.
sizelimit
-
Enables you to limit the count of entries fetched. Setting this to 0
means no limit.
Зауваження:
This parameter can NOT override server-side preset sizelimit. You can
set it lower though.
Some directory server hosts will be configured to return no more than
a preset number of entries. If this occurs, the server will indicate
that it has only returned a partial results set. This also occurs if
you use this parameter to limit the count of fetched entries.
timelimit
-
Sets the number of seconds how long is spend on the search. Setting
this to 0 means no limit.
Зауваження:
This parameter can NOT override server-side preset timelimit. You can
set it lower though.
deref
-
Specifies how aliases should be handled during the search. It can be
one of the following:
controls
-
Array of LDAP Controls to send with the request.